![]() This ability to define what motion will trigger the motion detection software to activate the camera can be particularly handy if you’re worried about setting the camera off too often. Then click Motion Detection from the side menu, click Enable, and specify which blocks in the image you would like to monitor for motion. Most webcam motion detection features let you specify which areas of the image you want it to pay attention to.For this D-Link camera, open the Web interface and click Setup. Instead, I had to update the camera’s firmware and run the wizard a second time, using the following instructions. On my first attempt, though, I couldn’t get the camera to connect to the wireless network or register with D-Link’s Web-monitoring portal,. Depending on the version of your software and on your network connection, everything might be running just fine by the time you reach the end of the wizard. For the setup wizard to work, your PC will must be on the same network as the camera. Once your camera is plugged in, navigate through the setup wizard provided on the CD. Alternatively, if your router supports Wi-Fi Protected Setup (WPS), plug the camera into a power outlet, open the D-Link setup wizard on the included CD, from a PC connected to the same network as the camera, and press the WPS button when the wizard tells you to. Connect the camera via ethernet to your router (if your wireless router has a built-in ethernet switch in it) or to a connected ethernet switch. If you have a different camera, the setup process will vary, but it’s likely to be quite similar.ĭ-Link’s provided setup wizard can be handy, but we had to update the firmware first.Start out by plugging the camera into a power outlet close to your Wi-Fi router. These directions are specific to the D-Link camera that we’re using. Step 2: Configure Your Wireless Network Camera If you get strong signals from other networks on the same channel as your network, change the wireless network broadcasting channel in the setup interface of your wireless router to something that your neighbors aren’t using. If your neighbor’s wireless network uses the same channel that yours does, the competition can make it harder for your Wi-Fi devices to connect to each other. You may now enjoy viewing your camera even when you are away.If you’re concerned about your camera’s wireless network reception in the spot you’ve selected, you can use a Wi-Fi stumbler app like InSSIDer or NetStumbler to see whether any nearby networks are running on the same channel as your home network. You will get this message once setup is complete. While finishing the setup, an overview of what you can do in the app will appear Your phone will now connect to the camera's WIFI. If not, the instruction on how to set it to Pairing mode, if it isn't yet, will be shown by tapping the 'Here' label in the app. ![]() Once you reach this, enter the WiFi password then tap Next. Tap Start again and select which store you purchased your unit to proceed ![]() (If you don't have its QR code, tap Manual Pair and get the MAC Address above the Serial number then click HERE ) Scan the QR code sticker attached to your camera. Tap Menu (upper left) then select Pair Device. Also, for faster setup, connect your phone to the WiFi where you wish to setup the camera to. Other compatible cameras will have a similar setup.īefore we start, you need to make sure that you not only download the app, but also register an account.
0 Comments
Leave a Reply. |